[QLI2.0] [hamoa-iot-evk] [lemans-evk] [monaco-evk] imx412 sensor probe failure

[sgaud-quic]

Board: hamoa-iot-evk, lemans-evk, monaco-evk
Kernel : qcom-6.18.y
LAVA: https://lava.infra.foundries.io/scheduler/job/442980
https://lava.infra.foundries.io/scheduler/job/442951

[   14.222829] imx412 4-001a: supply avdd not found, using dummy regulator
[   14.223444] EDAC DEVICE0: Giving out device to module qcom_llcc_edac controller llcc: DEV qcom_llcc_edac (INTERRUPT)
[   14.223998] /soc@0/isp@acb7000: Fixed dependency cycle(s) with /soc@0/isp@acb7000/phy@ace6000
[   14.224223] platform iris_non_pixel.0: Adding to iommu group 17
[   14.224490] platform iris_pixel.0: Adding to iommu group 18
[   14.237058] imx412 4-001a: failed to find sensor: -5
[   14.239080] qcom-spmi-lpg c42d000.spmi:pmic@1:pwm: probe with driver qcom-spmi-lpg failed with error -22
[   14.245998] imx412 4-001a: probe with driver imx412 failed with error -5

[nihal231998]

Salendarsingh Gaud (@sgaud-quic) could you please confirm imx577 camera sensor is connected to which slot?

The logs show: imx412 4-001a: probe with driver imx412 failed with error -5
We have faced similar issue, when imx577 sensor is not present on device or not connected properly.

[sgaud-quic]

Bhargav-qcom (@bhargav0610) / Anil (@qcom-anilyada) to comment here

[qcom-anilyada]

these devices don't have a camera connected, has-camera tag also is not present on the device

hyd-worker-04 - hamoa-iot-evk-04
ostt-lts-hyd-08 - rb8-hyd-08

[nihal231998]

If the sensor is not connected, please verify and close this ticket, as the issue is expected when the sensor is not available/connected.

[lumag]

Instead of closing this ticket, pelase fix the tests to use only the tagged hardware.

[sgaud-quic]

Nihal Kumar Gupta (@nihal231998) the issue is not seen on any particular test case, but is seen during boot, so you mean the camera should be connected to all the devices ?

Bhargav-qcom (@bhargav0610) to comment from test side.

[nihal231998]

Nihal Kumar Gupta (@nihal231998) the issue is not seen on any particular test case, but is seen during boot, so you mean the camera should be connected to all the devices ?

Yes, the camera probe happens during the boot time, and if the camera is not connected, the probe will fail.